DSP Tricks: Sharpening Your FIR Filters

by Richard G. Lyons , TechOnline India - November 16, 2009

Richard Lyons, author of "Digital Signal Processing," describes a couple of techniques for improving the stopband attenuation of a digital filter.

Here's an interesting technique for improving the stopband attenuation of a digital under the condition where we're unable, for whatever reason, to modify that filter's coefficients.

Actually, we can a filter's double stopband attenuation by cascading the filter with itself. This works, as shown in Figure 13-32(a) below, where the frequency magnitude response of a single filter is a dashed curve |H(m) | and the response of the filter cascaded with itself is represented by solid curve |H2(m) |.

Figure 13-32 Frequency magnitude responses of a single filter and that filter cascaded with itself: (a) full response; (b) passband detail.

The problem with this simple cascade idea is that it also doubles the passband peak-to-peak ripple as shown in Figure 13-32(b). The frequency axis in Figure 13"32 is normalized such that a value of 0.5 represents half the signal sample rate.

Well, there's a better scheme for improving the stopband attenuation performance of a filter and avoiding passband ripple degradation without actually changing the filter's coefficients. The technique is called filter sharpening, and is shown as HS in Figure 13-33 below.

Figure 13-33 Filter sharpening process.

The delay element in Figure 13-33 is equal to (N"1)/2 samples where N is the number of h(k) coefficients, the unit-impulse response length, in the original H(m) FIR filter. Using the sharpening process results in the improved |HS(m) | filter performance shown as the solid curve in Figure 13-34 below, where we see the increased stopband attenuation and reduced passband ripple beyond that afforded by the original H(m) filter.

Figure 13-34 [H(m)] and [Hs(m)] performance: (a) full frequency response; (b) passband detail.

Because of the delayed time alignment constraint, filter sharpening is not applicable to filters having non-constant group delay, such as minimum-phase FIR filters or IIR filters.

If perhaps more stopband attenuation is needed then the process shown in Figure 13-35 below can be used, where again the delay element is equal to (N-1)/2 samples.

Figure 13-35 Improved filter sharpening FIR process.

The filter sharpening procedure is straightforward and applicable to lowpass, bandpass, and highpass FIR filters having symmetrical coefficients and an odd number of taps. Filter sharpening can be used whenever a given filter response cannot be modified, such as an unchangeable software subroutine, and can even be applied to cascaded integrator-comb (CIC) filters to flatten their passband responses, as well as FIR fixed-point multiplierless filters where the coefficients are constrained to be powers of two.

Used with the permission of the publisher, Prentice Hall, this on-going series of articles is based on copyrighted material from "Understanding Digital Signal Processing, Second Edition" by Richard G. Lyons. The book can be purchased on line.

Richard Lyons is a consulting systems engineer and lecturer with Besser Associates. As a lecturer with Besser and an instructor for the University of California Santa Cruz Extension, Lyons has delivered digitasl signal processing seminars and training course at technical conferences as well at companies such as Motorola, Freescale, Lockheed Martin, Texas Instruments, Conexant, Northrop Grumman, Lucent, Nokia, Qualcomm, Honeywell, National Semiconductor, General Dynamics and Infinion.

About Author


blog comments powered by Disqus